Berita & Blog

Jul 22, 2026

Horn Gap vs Rod Gap Arresters: Where Each Design Is Used

Before zinc oxide varistors existed, overhead lines were protected by air itself. A horn gap arrester stretched an arc between two diverging horns until it...

Read More

Jul 21, 2026

Disconnector vs Isolating Switch: How the Terms Are Used in MV Systems

A disconnector switch decision is reliable only when the project distinguishes terminology, isolation duty, document evidence, and supplier exceptions. Treat the requested device as an...

Read More

Jul 21, 2026

Metal-Oxide vs Silicon Carbide Lightning Arresters: A Technical Comparison

Distribution networks that have been in service for several decades usually carry two generations of overvoltage protection side by side. New purchases are almost always...

Read More

Jul 20, 2026

Transformer Surge Arresters: Coordination Questions Before Selection

A transformer surge arrester is not selected from transformer voltage alone. The coordination decision begins at the protected terminals: identify the transformer insulation requirement, the...

Read More

Jul 20, 2026

Lightning Arresters for Substations: Protection Scope and Selection Inputs

For a substation project, a lightning arrester for substation is not a stand-alone promise that every connected asset will be protected. It is a location-specific...

Read More

Jul 20, 2026

High Voltage Fuse Cutout for Power Utilities | Distribution Line Protection

High voltage fuse cutout remains an important protection device in overhead power distribution networks as utilities, electrical contractors, and EPC companies continue to upgrade aging...

Read More